Lehigh Home
F&A Policies

EH&S Home
Safety Bulletin
Newsletter
Contact EHS
FAQ
Forms
Accident Reporting
Emergency Procedures
Policies
Training and Orientation
Right to Know
Computer Disposal
Programs

Welding, Cutting, and Brazing Policy

Introduction

To provide the safety requirements for welding, cutting, and brazing in accordance with 29 CFR 1910.251 of the Occupational Safety and Health Administration.

Policy
  1. Responsibility
    1. Each department engaged in welding, cutting, or brazing operations shall do so in accordance with OSHA 29 CFR 1910.251 and this policy.
    2. The Supervisor/Manager of each department conducting welding, cutting, or brazing operations shall be responsible for enforcing this policy.
    3. Outside contractors performing work on University property are required to follow the requirements of OSHA's 29 CFR 1910.251 and this policy.
  2. Hazards

    There are several hazards to consider when performing welding, brazing, or cutting operations. These hazards include fires, explosions, electrocution, burns, welder's flash, oxygen depletion, and toxic fumes. Each Supervisor/Manager will be responsible to ensure their personnel are aware of these hazards and have taken adequate steps to prevent such an occurrence.

  3. Personal Protective Equipment

    It is the responsibility of the Supervisor/Manager to ensure each employee utilizes the appropriate equipment required to safely perform welding, cutting, or brazing operations. This includes personal protective equipment listed below:

    1. Respirators should be used when ventilation is less than adequate.
    2. Flame retardant clothing should be worn to prevent clothing from catching on fire.
    3. High top boots should be worn to prevent burns to the legs and feet.
    4. Gloves are recommended to prevent hand burns.
    5. All personnel are required to use an approved welder's shield or goggles. All shields must be ANSI (American National Standard Institute) approved and the proper shade for the type of operation being performed.
  4. Training

    Supervisors/Managers are required to ensure personnel who weld, cut, or braze have received proper training. They are also responsible to ensure personnel are trained in the following areas:

    1. Fire extinguisher use.
    2. Respirator training, if they are required to use a respirator.
    3. How to respond to an emergency (emergency numbers and alarm locations).
    4. Confined space training, which includes all requirements of the Confined Space Policy, if personnel are required to work in confined spaces.
    5. Personal protective equipment and the type of shield required for their specific operation.
  5. Permits
    1. A welding permit is required for each welding project and should be renewed each day. Copies of permits shall be obtained and filed by the Department Supervisor/Manager.
    2. Outside contractors are required to obtain permits from Facilities Services before the beginning of each project. The contractor is required to complete each permit and fulfill each requirement before work begins.
For more information regarding this policy, contact Environmental Health and Safety 610-758-4251.
F&A DEPARTMENTS


Back to F&A Home
F&A Policies


Lehigh University • 616 Brodhead Avenue • Bethlehem, PA 18015 • 610.758.4251
© 2008 Lehigh University • All Rights Reserved • Produced by IMRC.
Emergency Information • Copyright • Terms of Use • Privacy Policy